DIY Glider Rocking Chair Cushions

Author: | Categories: Rocking Chair comments
Glider Rocking Chair Cushions Ideas

Glider rocking chair cushions – Glider rocking chairs give you all the smooth movement of a traditional rocker, without feeling that tilts back and forth. If you like spending time in her rocking chair, but you cannot bear the pain of the bottom you have left after hours on the wooden seat, you can make a glider rocking chair cushions to relieve pain. Then you can enjoy rocking back and forth without all the awkward movement that comes with sitting in a wooden chair. Measure the seat of his rocking chair – you need this measure to get a proper size mattress. With this measure, visit a craft store or home furnishings retailer and buy a flat seat cushion that fits your rocker – from rockers are relatively uniform in size, this is not difficult. You can also replace a thick foam pad for a real mattress, because it will be covered by the end of the project.

Buy several meters of fabric to make glider rocking chair cushions. While upholstery fabric is more durable, feel free to use any type of tissue or cotton blend for this project. You need about 1/2 yards of fabric more than double the size of your mattress. Cut the fabric so that you have two squares, each of which is a number larger than the mattress inches on each side. Place the square top of each other so that the outside of the faces of the fabric then pin together on three sides. Slide the pad into the opening to make sure it fits. Use a sewing machine to stitch the two squares together along three sides, leaving one of them open to make a pouch like a pillowcase cushion. Turn the fabric inside out so that the seam is hidden inside the box.

Best Post |  Best Double Rocking Chair Function

Cut two strips of cloth from his extra material. Each strip should be at least 4 inches long and 1 inch wide. Iron them to be flat and straight and then make a straight-stitch 1/4-inch from the edge along both sides of each strip. Pin the center of the strips of the corners along the opening of the pad box. Use a small straight stitch to keep it in place and then repeat the process with the other strip in the adjacent corner. Place the seat cushion on the rocker with the opening facing the back of the chair. Gently secure it in place by tying the two strips around the vertical slats of the chair.

Comments are closed.